I am just trying to make end to end service up via l2vpn-evpn in the attached setup.
and it was sucessful, EtoE reachable.
But when i am trying the see the Mac address learned via vni, I am unable find and even Type-2 route is not visible.
attaching the configuration below.
set interfaces bridge br409 enable-vlan
set interfaces bridge br409 member interface eth4 allowed-vlan ‘409’
set interfaces bridge br409 member interface vxlan409 allowed-vlan ‘409’
set interfaces vxlan vxlan409 parameters nolearning
set interfaces vxlan vxlan409 port ‘4789’
set interfaces vxlan vxlan409 source-address ‘192.168.24.1’
set interfaces vxlan vxlan409 vni ‘409’
set protocols bgp address-family ipv4-unicast maximum-paths ibgp ‘4’
set protocols bgp address-family ipv4-unicast redistribute connected
set protocols bgp address-family l2vpn-evpn advertise-all-vni
set protocols bgp address-family l2vpn-evpn vni 409 advertise-svi-ip
set protocols bgp address-family l2vpn-evpn vni 409 rd ‘409:409’
set protocols bgp address-family l2vpn-evpn vni 409 route-target export ‘192.168.24.1:409’
set protocols bgp address-family l2vpn-evpn vni 409 route-target import ‘192.168.24.1:409’
set protocols bgp neighbor 192.168.24.2 peer-group ‘evpn’
set protocols bgp neighbor 192.168.24.2 update-source ‘192.168.24.1’
set protocols bgp parameters log-neighbor-changes
set protocols bgp parameters router-id ‘192.168.24.1’
set protocols bgp peer-group evpn address-family ipv4-unicast nexthop-self
set protocols bgp peer-group evpn address-family ipv4-unicast route-reflector-client
set protocols bgp peer-group evpn address-family l2vpn-evpn nexthop-self
set protocols bgp peer-group evpn address-family l2vpn-evpn route-reflector-client
set protocols bgp peer-group evpn capability dynamic
set protocols bgp peer-group evpn remote-as ‘64555’
set protocols bgp system-as ‘64555’
