How to set a static IPv6 to pppoe interface

[felipemiranda]

I could not find a way to set a static IPv6 to pppoe interface. Can it be done?

[himurae]

IPv6 does not seem to be working on PPPoE interfaces in the 1.4 nightly builds

Try these commands set interfaces pppoe pppoe0 authentication password xxxxxx set interfaces pppoe pppoe0 authentication username xxxxxx set interfaces pppoe pppoe0 dhcpv6-options pd 0 interface eth1 address ‘1’ set interfaces pppoe pppoe0 dhcpv6-options pd 0 interface eth1 sla-id ‘0’ set interfaces pppoe pppoe0 ip adjust-mss ‘clamp-mss-to-pmtu’ set interfaces pppoe pppoe0 ipv6 address autoconf set interfaces pppoe pppoe0 ipv6 adjust-mss ‘clamp-mss-to-pmtu’ set interfaces pppoe pppoe0 source-in…

[c-po]

@felipemiranda usually the static IP addresses both v4 and v6 are handed out by the BRAS on the other side.

[felipemiranda]

Sorry I am a bit new to this network stuff specially with ISP, what is BRAS?

[tjh]

@felipemiranda

what is BRAS

The device that your router is speaking PPPoE to. It’s the ISPs network device. It stands for Broadband Remote Access Server - also often called a BNG (Border Network Gateway)