My first time vyos experience!

[ishan]

@ishan

4. This can be a small improvement. I’ll prefer the ability to select interface groups when configuring SNAT rules. I had to add multiple rules (1 for each WAN)

set nat destination rule 2 inbound-interface eth1
set nat destination rule 2 inbound-interface pppoe0
set nat destination rule 2 inbound-interface wg1

If it was possible to select interface groups here I could do,

set nat destination rule 2 inbound-interface interface-group WAN

5. Similar problems as 4. It’s not possible to select interface groups in load-balancing rules.

From other threads, It looks like this may not be possible today

GitHub - vyos/vyatta-wanloadbalance: vyatta wan load balance project

WAN load-balancing source/destination group support

This is almost impossible due to the old backend for loadbalancing