Hi!
On a fresh install of VyOS 1.2.0RC10 in RAID-1 on 2 500G SSDs, I’m unable to save config.
There are no error messages, but /config does not get created by command save.
Any idea?
Hi!
On a fresh install of VyOS 1.2.0RC10 in RAID-1 on 2 500G SSDs, I’m unable to save config.
There are no error messages, but /config does not get created by command save.
Any idea?
I have the same issue on one if my systems.
I was not really sure if the issue was at the SW-RAID1 or the new UEFI Boot function.
Did you use the UEFI Install/Boot?
Yes I did. On the same system using UEFI, the problem does not occur if I install on a single disk.
Exactly the same for me.
Seems like there is an issues when you combine the SW-RAID1 and UEFI Boot.
Would you mind to open an bug report about that issue?
https://phabricator.vyos.net/
I have some similar issues, check ⚓ T1120 rc11 raid-1 array wont come up on boot and see if it matches your experiences.
See the linked phabricator task. Does booting with acpi=off
or rootdelay=10
as mentioned correct it for you too?